3.1: Run a test to determine power settings for cutting and engraving the synthetic suede material.

3.2: Copy and paste two or three circles from your pattern well outside of the area in which you plan to engrave.

3.3: Focus the laser and adjust the power and speed settings as necessary so that you cut and engrave the circles successfully in the synthetic suede as shown in Graphic 3.

Tip: Engraving synthetic suede does not require much laser power. Begin your test by engraving at a low power setting and high speed and increase the power as necessary.

<Previous Page • Intro 1 2 3 4 5 • Next Page >

«Back to "How to"